

Furuno has been building marine electronics since 1948, and it is the backbone of nearly every wheelhouse we wire. We stock it, install it, calibrate it and repair it — with factory-trained techs and genuine parts, right here in Sou'West Nova Scotia.
Not a catalogue — this is what actually goes into the packages we build, pulled from the vessels on our fleet page.

Our most-installed radar family. Target Analyzer colours moving targets, RezBoost sharpens bearing resolution, and Doppler tracking picks gear and small craft out of sea clutter.

The two sounders we sell most. The DFF1-UHD+ replaces the discontinued BBDS1 and gives bottom discrimination on 50/200 kHz; the DFF3D adds multibeam side-scan and live 3D bottom mapping — the picture most of our fleet actually runs. The 2kW DFF3 is there for the deep-water boats that need raw power, but DFF3D and DFF1-UHD+ cover the majority of what we install.


Heading you can steer and stabilize radar with — no spinning gyro, no magnetic deviation. Feeds heading, pitch, roll and heave to the radar, sounder and autopilot over NMEA 2000.

The standalone backup set. Cheap insurance on a long steam — a second, fully independent radar picture when the network scanner is down or the wheelhouse is busy.

Simple, bulletproof position and waypoint display. Usually installed in pairs as a rredundant position source for the pilot, computer plotters, VHF/DSC ETC

A compact, daylight-readable instrument display that shows depth, speed, wind, heading and more at a glance. Plugs into the NMEA network and can also be used as a Rudder Angle Indicator (RAI) on Simrad autopilots.

Standalone 8.4" CHIRP sounder with TruEcho CHIRP, bottom discrimination, ACCU-FISH and colour range expansion. A clean, purpose-built sounder screen for boats that want their bottom picture off the plotter.

The workhorse standalone sounder — free-select frequency, ACCU-FISH and a bright 10.4" display. Built for hard commercial use where the sounder has to stay readable all day. Also outputs hardness information to TZ and Olex

Furuno's deep-water sounder. Up to 3kW of output with a 12.1" display, free-select frequency also outputs hardness information to TZ and Olex— The sounder for Boats fishing Offshore depth

A dedicated radar display for boats that want their DRS scanner running on its own screen instead of through TimeZero. Same NXT scanner picture, standalone control head — no PC in the loop.

The reason we lean on Furuno is integration. Radar, Timezero Sounder and Satellite Compass all share the same network, so heading-stabilized radar overlays sit right on the TimeZero chart alongside live bottom data. We build the bridge as a system, label every run, and hand you a boat you can actually service.
New build, refit or a single failing unit — call us and we will put together a package that fits the boat and the fishery.