Victron Energy builds the power side of a modern boat — inverter/chargers, MPPT solar controllers, DC-DC converters, lithium batteries and the Cerbo GX and VictronConnect platform that puts the whole system on your phone. We design, build and service marine DC and AC power around Victron gear, from a single charger to a full lithium bank with remote monitoring.
Not a catalogue — this is what actually goes into the packages we build, pulled from the vessels on our fleet page.

A true sine wave inverter, adaptive battery charger and automatic transfer switch in one box. PowerAssist boosts a limited shore or generator supply with battery power instead of tripping the breaker, and the UPS transfer happens in under 20 milliseconds so plotters, sounders and computers never blink. Adaptive four-stage charging with battery-safe mode looks after flooded, AGM, gel or lithium banks, and up to four units can run in parallel for more output. Pair it with a Cerbo GX and you monitor and control the whole system from VictronConnect or the VRM portal, on board or from home. We stock and fit the 12V and 24V 3000VA models as our standard offering for working boats.

High-efficiency switchmode DC-DC converters that step battery voltage up or down to keep every part of a 12/24/48V boat on the right rail. The Orion line covers both straight-through converters (to hold a 12V electronics bus from a 24V house bank) and dedicated battery-charger converters that profile and maintain a secondary bank with adaptive charging. Models span 12V, 24V, 48V and 110V inputs with continuous currents up to 70A (85A peak on the 24/12-70), remote ON/OFF for clean panel switching, and a fully isolated, fan-less ribbed housing rated for engine-room heat. We size, fuse and install Orion converters as part of a Victron power system so chargers, lithium banks and electronics all share one clean DC architecture.

The value in Victron is that everything talks. We commission the charger, solar and battery monitor onto the same GX device so you get one honest picture of state of charge, loads and generation — on the boat or from home.
New build, refit or a single failing unit — call us and we will put together a package that fits the boat and the fishery.